Różnice
Różnice między wybraną wersją a wersją aktualną.
Both sides previous revision Poprzednia wersja Nowa wersja | Poprzednia wersja Nowa wersja Both sides next revision | ||
druk3d:start [2020/03/15 02:12] igor [FLEX] |
druk3d:start [2020/07/17 09:07] igor [Specjalne, polecane] |
||
---|---|---|---|
Linia 12: | Linia 12: | ||
* PLA od Colorfila i druk 230 st | * PLA od Colorfila i druk 230 st | ||
=====Specjalne, polecane===== | =====Specjalne, polecane===== | ||
- | Fiberology PLA HD https://sklep.gamplate.pl/filament-fiberlogy-pla-czerwony-p-121.html po wygrzaniu staje się **odporny do 140*C!** | + | * WypunktowanieFiberology PLA HD https://sklep.gamplate.pl/filament-fiberlogy-pla-czerwony-p-121.html po wygrzaniu staje się **odporny do 140*C!** |
+ | * Fiberology Varioshore TPU - piankowy, gęstość zależna od temperatury | ||
+ | * Fiberology LW PLA - piankowy superlekki zależny od temperatury | ||
======Prusa - problemy i rozwiązania====== | ======Prusa - problemy i rozwiązania====== | ||
=====FLEX===== | =====FLEX===== | ||
Linia 23: | Linia 25: | ||
Ręczne ładowanie filamentu (autoload może się okazać za szybki dla gumowych) | Ręczne ładowanie filamentu (autoload może się okazać za szybki dla gumowych) | ||
- | the improved part cooling fan can and will activate when doing bridging and this made my hotend drop 20-25 degrees in a few seconds and then the print failed. | + | the improved part cooling fan can and will activate when doing bridging and this made my hotend drop 20-25 degrees in a few seconds and then the print failed.i would recommend getting getting one of those blue silicone sockets to put over your hotend (if you haven't already) |
+ | it makes the temperature much more stable and i think this problem is why i had sometime issues with PETG and getting first and second layer to stick together properly (going to lower temperature at same time as part cooling fan comes on on second layer creates a big drop in temp without the silicone socket) | ||
+ | __ | ||
+ | |||
+ | To get the gears near the slip moment is the trick. That means during regular, good scenarios it doesn't slip. But once there is too much resistance the gears would slip instead of pushing the filament out of the filament path. | ||
+ | |||
+ | Slowing the speed, increasing temp, reducing retractions is something you have to do anyway.__ | ||
+ | |||
=====Za mocny wiatrak na dyszę w Mk3s===== | =====Za mocny wiatrak na dyszę w Mk3s===== | ||
Zmieniono wiatrak i kanał, nie redukując prędkości w ustawieniach Slicera. Można trochę zredukować ręcznie. | Zmieniono wiatrak i kanał, nie redukując prędkości w ustawieniach Slicera. Można trochę zredukować ręcznie. |